Precision II Cleaning & Oil Kit (Red Oil)

Precision II Cleaning & Oil Kit (Red Oil

Step 1

REMOVING AND CLEANING

• Clean the sealing area of the filter and the filter housing with a clean, soft cloth.
• Tap the filter on a hard surface to remove and loosen large particles and dirt.(A soft brush can be used to loosen large dirt particles or insects.)
• Use S &B's Filter Cleaner to clean the filter.
• Gently rinse the cleaner with low pressure water.
• Let the filter dry for at least 24 hours.

Step 2

FILL AND APPLY

• Fill the applicator with the exact amount of oil needed for your filter.
• Start on half of the base and make 2-3 passes around the perimeter of the filter in the same area.
• Repeat this process evenly spacing the passes.

Step 3

INSPECT AND INSTALL

• Let the oil bleed for 20-30 minutes.
• Inspect the filter for white spots that are not covered by the oil.
• With the remaining oil in the applicator, apply a small amount of oil to those white areas.
• Do not lubricate your filter too much.